Which one of the following is a Class A Combustible material that can act as fuel found in non specialized areas such as offices:

Water is the best fire extinguishing agent available for Class B fires caused by flammable liquids:

Welding process may use __ which may cause fire hazard:

Exposure to high concentration of halon results in oxygen deficit atmosphere. This can cause:

Alarms provided at the workplace buildings should be only audible type (visual alarms should not be used)

The light intensity for visual alarm should be at least ___ :

Audible alarms should exceed at least ____ than the normal ambient noise level:

Fire is a very rapid chemical reaction between the oxygen and non-combustible materials generating heat and light:

What are the elements of “Fire Triangle”:

Which type of extinguishers are employed to put-off the electrically energized fires:

In place of normal wiring, electrical cords can be replaced in order to prevent the fire hazards:

Which of the following cannot cause fire hazard:

A 8-A rated extinguisher would be equal to ____ gallons of water

Water Extinguishers should only be used on ___ fires

Fire extinguisher generally not do one of the following action for extinguishing the fire:

How many exit routes should be provided in a workplace in order to permit prompt evacuation during emergency:

For exit side-hinged exit doors should always be used:

An exit access should be at least ___ wide at all points

Class K fire extinguisher should be mounted within ____ from commercial food equipment using vegetable or animal oils

Fire extinguishers should be inspected once in every ___

Which one of the following code states that alarm signal to be distinctive in sound from other signals and cannot be used for any other purpose:

Bells, Horns and Sirens are most efficient and effective means of audible alarms for evacuating the people during emergencies:

Alarm devices should be protected from corrosive environment:

Halon is a bromo freon meant for extinguish the fire:

Which of the following extinguishers use potassium acetate based, low PH agent for extinguishing the fire:

It is the responsibility of the employees to Control fuel source hazards in the workplace:

Who determines the fire prevention and protection policies:

Who is responsible for carrying out fire risk surveys and make recommendations for improvement

Extension cords shall be used in place or normal wire in order to reduce fire accidents:

To extinguish a fire caused by flammable liquids which extinguishing agent should not be used: