The maximum overcurrent protection for the primary windings of a transformer not over 600 V whose primary current rating less than 2 A is _____ :

The ampacity of the conductors from the Generator windings to the line side of the Generator over-current protection device must not be less than ______ of the nameplate current rating of the Generator:

The full load current (FLC) for 1 hp three phase alternating current motor supplied by 208 V supply voltage is _____ :

For a stationary motors of ______ hp or less, the branch circuit overcurrent device is permitted to serve as the disconnecting means:

NM cable run horizontally through the framing members is considered supported if secured within ______ of the termination:

Cables that runs across the top of floor joints or across the face of rafters or studding within ______ of floor must be protected by guard strips that are least as high as the cables:

Smooth Sheath Type MC cables must not be bent so that bending radius of the inner edge of the cable is less than _____ times the external diameter:

Receptacles located more than ______ from the wall or room divider may not be counted as required receptacles:

Type AC cables must be supported and secured at intervals not exceeding ______ :

The minimum distance between raceways enclosing the same conductors is ______ times the trade size of the largest raceway:

Box calculations for ______ and larger conductors under 600 V are performed based on the size and numbers of raceways:

A luminaire supported by a single conduit shall not exceed ______ in any horizontal direction from the point of conduit entry:

____ 10 AWG THHN conductors are permitted in 3/4 in AMC:

Single receptacles that provide shore power for boats must be rated not less than ____:

Land areas not subjected to tidal fluctuations is defined as the horizontal plane ____ above highest water level that occurs under normal circumstances:

PVC can be installed below a Class I area if buried under not less than ____ of cover:

Branch circuit conductors for information technology equipment must have an ampacity not less than _____ of the total load connected:

Audio system equipment supplied by a branch circuit must not be placed within ______ horizontally of the inside wall of a pool, spa, hot tub, fountain or prevailing tidal high water mark:

Underground wiring is not permitted under a pool or within _____ horizontally of the inside wall of a pool: