No parts of cord connected luminaries shall be located within a zone measured not less than ____ feet horizontally from the top of the bathtub rim

Securely fastened luminaries installed in or on the ceiling of the wall are permitted to be located in the bathtub or shower area:

Which of the following is/are examples of damp locations:

1. Some Cold Storage warehouses
2. Roofed open porches and carports

Cleat-type lampholders located at least ____ feet above the floor shall be permitted to have exposed terminals

Luminaries shall be installed, equipped with shades and guards such that combustable material is not subjected to temperatures in excess of ______

The minimum clearance between recessed fluorescent luminaries installed in wall or ceiling installed in clothes closets and the nearest point of the closet storage space is ______

Luminaries must be designed and installed not only to protect overheating of the conductors but also to prevent the overheating of adjacent combustible wall or ceiling finishes

A Hinged base Pole shall have a handhole if the height of the pole is less than 20 feet

Outdoor luminaries and associated equipment shall be permitted to be supported by trees

It is permitted to be provided with GFCI protection for personnel where luminaires are supplied by a circuit that does not have a equipment grounding conductors:

Lamp tie wires, mounting screws, and decorative bands on glass spaced atleast _____from lamp terminals shall not be required to be grounded:

Pendent Conductors for Incandescent Filament Lamps which are larger than ___ feet shall be twisted together where not cabled in a listed assembly:

Pendent Conductors for Incandescent Filament Lamps shall not be smaller than _____ for mogul-base or medium base screw shell lampholders

Stranded Conductors shall not be used for wiring of luminaire chains and another movable or flexible parts

Receptacles and attachment plugs shall have lower ampere rating not less than _____ of the luminaire full load current:

Which of the following is correct:

• Statement: Non metallic lampholders does not require bushings
• Reason: As the material and the design afford equivalent protection

In Cord Connected Installation for Electric Discharge and LED luminaires, the supply cord is not permitted to penetrate a suspended ceiling

______ number of individual showcases can be coupled together by a flexible cord that can be connected to permanently installed receptacles

Electrical rating of the Luminaire shall include only voltage and frequency rating

LED Driver is common industrial term referring to the power supply for the LED:

Which of the following Statement related to Portable Handlamps is/are Correct:

1. Shall be always Grounded
2. Shall be supplied through Isolation Transformer
3. Voltage should not be more than 50 Volts

When a 2-wire circuit is derived from two ungrounded conductors of a multiwire circuit and is used with switched lampholders, the switching device required is to be:

Lampholders near Combustible Materials shall be constructed, installed or equipped with shades or guards such that the combustible material is not subjected to exceed the temperature of about ____

Incandescent Lamp for general use on Mogul Base Lighting Branch Circuit Shall not be rated over _____

Thermal Protection shall be required in a recessed luminaire installed in poured concrete

Type IC recessed luminaires shall not be permitted to be in contact with combustible materials at recessed parts and points of support

Thermal Insulation shall not be installed above a recessed or within _____ inches of the recessed luminaire enclosure