A disconnect is required for all the conductors that enter a building:

The _____ clearance of overhead conductors from the roof edge does not apply when the point of attachment is on the side of the building below the roof:

IMC must generally be supported at intervals not exceeding _____:

The point of connection between serving utility and the premises wiring:

A standard fuse will clear the fault in ________:

The overcurrent protection for 10 AWG copper conductor must not exceed ______:

The total contact resistance is ______  if measured 5ft from the distance from rod:

The portion of the grounding electrode conductor that is the sole connection to one or more concrete encased electrodes is not required to be larger than _____:

Grounding electrode for premises wiring systems must be located no closer than ______ from lightning protection system grounding electrodes:

The Type 3 SPD connection must be a minimum ______ of conductor distance from the service or separately derived system disconnect:

FMC must be securely fastened within 1 ft of termination and secured and supported at intervals not exceeding ______:

Type MC cable can be unsupported for upto _____ past the last point where it is securely fastened to minimize vibration or provide flexibility:

FLC for a single phase AC motor rated 10 hp supplied by 208V is _____ :

The short circuit and ground fault protective device must not be less than _____ of the motor compressor current rating:

Dry-type transformers rated not more than _____ are permitted above suspended ceilings or in hollow spaces of buildings, if not permanently closed by the structure: