Type AC Cables shall be secured within _____ of every outlet box, junction box, cabinet or fitting:

A single volume allowance for one or more equipment grounding conductors enter a box having largest equipment grounding conductor of size 18 AWG is _______:

All _____ 125V receptacles installed in locker rooms with associated showering facilities must be GFCI protected:

Atleast one receptacle outlet must be installed at each island countertop space with a long dimension of ____ or more:

Lampholders connected to a branch circuit rated over ____ must be of the heavy-duty type:

If the assembly and the overcurrent devices are both listed for operating at ____ of their rating, the branch circuit overcurrent device can be sized at 100% of the continuous load:

If connected to a branch circuit that supplies two or more receptacles, 15A receptacles are not permitted on a 20A multiunit branch circuit:

Atleast one 125V, 15A or 20A receptacle outlet must be installed within ____ of the top of a show window for each 12 linear feet or major fraction thereof measured horizontally at its maximum width:

In case of dwelling unit a demand factor of ____ can be applied to the total connected load of four or more appliance loads n the same feeder/service:

The minimum distance from where the conductors enter the box or conduit body to the opposite wall must not be less than ____ times the trade size of the largest raceway:

Splices and taps can be installed in a cabinet if the splices or taps don’t fill the wiring space to more than _____:

Low voltage lighting systems for Pools, Spas, Fountains and similar locations must not be installed less than ____ from the edge of the water:

The branch circuit conductors and overcurrent devices for a fixed electric space heatig equipment must have an ampacity not less than _____ of the total heating loading:

If lighting outlets other appliances or general use receptacles are also connected to the circuit containing air conditioner connected, the rating of the room air conditioner cannot exceed ____ of the rating of the branch circuit:

The maximum primary protection of transformer rating not over 600V having primary current rating less than 9A is _____ of the primary full load current rating: