Underground metal water pipe is direct contact with the earth for ______ or more can serve as a grounding electrode:

The supplemental electrode for a rod electrode must be installed not less than _____ from the rod electrode:

A ground ring electrode that encircling the building consisting of atleast _______ of bare copper conductor:

Surge Protection Devices must not be used in circuits that exceed _____ :

Insulated equipment grounding conductors _____ and larger can be permanently reidentified at the time of installation at every point where the conductor is accessible:

The over Current protection for 12AWG copper conductors must not exceed ———–;

The Ampacity of service entrance conductors must be ——– of the continuous nodes connected;

The point of attachment of overhead service conductors must not be less than ——– above the finished grade;

Conductors are considered outside of a building when they are installed under not less than ——— of concrete beneath the building;

A cord is permitted for a dishwasher if the length is atleast ——- measured from the rear plane of the appliance;

Cord and plug connected equipment must not be rated more than ——– of the branch circuit ampere rating;

A circuit breaker can serve as motor controller;

The Ampere rating of hermetic refrigerant motor compressor must be atleast —— of the name plate rated load current;

Land area subject to tidal function is defined as the horizontal plane ___ above the highest high tide that occurs under normal circumstances:

Fixed lighting over travel lines, or if exposed to physical damage must be located not less than ____ above floor level, unless the luminaire is of the totally enclosed type or constructed to prevent sparks or hot metal particles from escaping:

For a fixed pier, all electrical connections must be located not less than ____ above the deck:

Each branch circuit or feeder that supplies a sign installed with in a fountain, or within ____ of the fountain edge, must be GFCI protected:

The overcurrent device provide for the protection of overcurrent protection for an assembly of fire pump must not open with a restart transient of ____ times the full load current of the fire pump motors:

At least one 15A or 20A, 125V receptacles must be located at least ____ from the inside wall of the spa or hot tub: