For a one family dwelling, the disconnecting means must have a rating not less than _____-, 3-wire:

Plug fuses are permitted to be used only when the circuit voltage does not exceed _____ between conductors:

Overcurrent protection for a 10AWG copper conductors must not exceed ______:

For buildings or installations consisting of two 2wire branch circuits, the service disconnecting means have a rating not less than _____:

Service entrance cables must be supported within ____ of the weatherboard, raceway connections or enclosures, and at intervals not exceeding 30in.

Overhead conductors must maintain a vertical clearance of at least _____ above platforms, projections r surfaces from which they may be reached:

The feeder/service VA load must not be less than 150 VA for every ____ of show window or track lighting or fraction of that length:

Wound rotor motor branch circuit must be protected using dual element fuse against short circuit and ground faults by a protective device sized no greater than ____ of the full load current:

Motor control conductors 14 AWG and smaller must be torqued at a minimum of ____ for screw type pressure terminal, unless identified otherwise:

Where a duct heater is located above a suspended the width of the working space for the duct heater must be not less than ____:

For the appliances rated at not more than ____ the branch circuit overcurrent protection device such as circuit breaker or plug fuse can serve as the appliance disconnect:

Conductors within ____ of ballast, LED driver, power supply or transformer must have an insulation temperature rating not lower than 90^oC.

A minimum clearance of _____ shall be maintained for surface mounted fluorescent luminaire from the closet storage space

A smooth inner surface with integral reinforcement within the raceway wall:

Type NM cable can be unsupported not more than _____ of unsupported cable is permitted from the last point of support within an accessible ceiling for the connection of luminaires or equipment: