Motors with a marked service factor (SF) of 1.15 or more on the nameplate must have the overload device sized no more than _______ of the  motor nameplate current ratings:

Allowable ampacity for 10 AWG copper conductor is _______ in the 60^o C Column:

Motor feeder tap conductors not over ______ long must have an ampacity not less than one-tenth the rating of the feeder protection device:

An electric heater having a capacity of _____ gallons or less is considered as continuous load for the purpose of sizing branch circuits:

Cord and plug equipment not fastened in place cannot be rated more than ______ of the branch circuit rating:

The maximum number of conductors permitted in a wireway is limited to ______ of the cross sectional area of the wireway:

Electrical nonmetallic tubing must be secured within _____ of every box, cabinet or temperature fitting such as a conduit body:

In building over 3 floors. ENT must be concealed behind floors, walls, or ceiling that have a _____ minute finish rating:

FMC Trade size 3/8 can be used in lengths not exceeding ______ for utilization equipment or tap connections to luminaires:

RMC is not required to be securely fastened within _____ of the service head for an above the floor termination of a mast:

A vertically mounted luminaire weighting no more than ______ can be supported to a device box or plaster ring secured to a device box:

The portion of the grounding electrode conductor that is the sole connection to one or more ground rod is not required to be larger than _____:

Separately derived systems rated ______ or less are not required to be grounded:

The overcurrent device for the main marina feeder conductors must have ground fault protection not exceeding _____:

If multiple power sources supply portable structures, the circuit equipment grounding conductors at each portable structures must be bonded together for all portable structures separated by less than ____:

Mobile and manufactured home pipe heat tape receptacle outlets must be located on the underside of the unit and within ______ of the cold water inlet:

All fixed metal parts must be bonded to the equipment grid if located more than ____ horizontally from the inside walls of the pool structure:

Underwater luminaires must be installed so that the top of the luminaire lens is not less than _____ below the normal water level:

For fixed or stationary equipment other than an underwater luminaire for permanently installed pools , cord must have a copper equipment grounding conductor not smaller than _____ and the cord must terminate at a grounding type attachment plug: